One of our gas turbine generator unit "1st stage rotor
ground fault" alarm was occured several times. we tried to
measure some voltage vulue ground fault protection relay
(UNS3020a made by ABB and we measured the value of:
Ground: 0.9VDC
5V: 5.8VDC
24V: 23VDC
u+: 300 – 350mVAC
Rf1: 17.5mVAC
Rf2: 17.6mVAC
The unit still running and the alarm was reset. As of 6pm
yesterday and unitl now no alarm happened again. I our
protection relay was defective?
Answer / yvb
Stage 1 Alarm is only Alarm...Stage II is trip..so your
system working Ok...
| Is This Answer Correct ? | 0 Yes | 0 No |
what is the contact resistance of Air circuit breaker??
how to select cable size according to ampere.
How may I get the maximum current capacity for a particullar size Alluminum or Copper cable if there is compulsion to use?
1.wat is the purpose (or)function of regulator? 2.wat is the purpose of stabiliser?
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
Explain the laying procedure and laying depth of submarine cables under sea?
what is the difference between squirrel cage & slip ring induction motor by construction & working principle ?
Negative feedback circuit is an implication of ? -Shunt shunt -Shunt series -series series
How calculated single phase induction motor req. Capacitor?
what is maximum demand.
define reactive power?
For Electrical / and Electronic Systems, when we say efficiency is 80%, then what happens to other 20% from the Power consumption.? I.e. what happens to this?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)