WHAT IS TANK CKT.?

Question Posted / gajendra_gupta09

4 Answers
8587 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

WHAT IS TANK CKT.?..

Answer / naveen singh

tank ckt. consist of capacitance and inductance connected
in parallel. this ckt. is mainly used to make higher
frequencies.

Is This Answer Correct ?

9 Yes

2 No

WHAT IS TANK CKT.?..

Answer / amit. thapar

it is a parallel combination of capacitor and inductor choke.
which offers the high impedance at its(tuned)resonsnce frequency. and resonce freq. is Fr=1/(2*3.14*f*c)
where
f=frequency
Fr=resonance frequency
pye=3.14
c=capacitance of ckt.
this ckt r used in tuned amplifier etc. for getting the desired high gain at resonance frequency.

Is This Answer Correct ?

6 Yes

0 No

WHAT IS TANK CKT.?..

Answer / pran

TANK CIRCUIT IS A COMBINATION OF CAPACITOR AND
INDUCTOR.WHILE DISCHARGING THE CAPACITOR, THE INDUCTOR IS
CHARGED. AND OPPSITE INCIDENT INDUCTOR WILL REVERTBACK THE
ENERGY. THIS WILL ACT AS A OSCILLATOR FOR PRODUCING
FREQUENCYS

Is This Answer Correct ?

5 Yes

2 No

WHAT IS TANK CKT.?..

Answer / hemant mutha

BEACAUSE of charging and discharging of Capasiter and
principle of inductor to oppoe change in current
oscillations produced

Is This Answer Correct ?

0 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

What is cathode ray oscilloscope (cro)?

0 Answers

would the same effect be achieved by reversing the connection to one winding of the induction motor 3-phase?

0 Answers

how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.

0 Answers

How can we parallel two transformer with vector gorup YNd11 and YNd1?How is connection two transformer GT?

3 Answers

What is the role of the 50 STUB protection at a GIS 400KV substation with SIEMENS protection relays?

0 Answers Power Plant,

what is the difference b/w ATS and HTS?

0 Answers Mikano,

sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.

0 Answers

140 is load amps for a equipments and what ratio of CT requied for installimg ammeter to amps montering purpose?

1 Answers

What is the knee point voltage of CT-100/5,15VA,5P20 ?

3 Answers ERL, NTPC,

Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.

0 Answers ABB,

Why we are mostly using a single 3-phase transformer instead of three 1-phase transformers?

7 Answers

Can any body describe me why a soft starter is used for 6.6kv induction motor instead of VFD ?

1 Answers Cairn,

For more Electrical Engineering Interview Questions Click Here