Answer / richard marks

ph meters are calibrated using buffer solutins which are at
known ph levels. Make sure the probe is cleaned before
imerging it in the solutions.

Answer / satish

YOU CAN CALIBRATE IN THREE PHASE 4/7/9 PH BUFFER SOLUTION
NORMALLY WE ARE CALIBRATING WITH 4 & 9 PH BUFFER THAT MEAN
4PH--4MA/9PH--20

Answer / subhash

the Ph calibration is done by using the buffer solutions
,with the one probe i,e the reference electrode and the
measurement electrode ,,,,,,,,,,,,,

Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor

0 Answers   CCIE,

---

what is modbus & what signals are taken through it

2 Answers  

---

What do you know about gail?

0 Answers   GAIL,

---

how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.

0 Answers  

---

I want to measure bidirectional steam flow? Kindly suggest me a suitable flow meter. steam is superheated at 41kg/cm2, 350°C

2 Answers  

---

WHAT IS THE DIFFERENCE BETWEEN A TRANSMITTER & A SMART TRANSMITTER.

8 Answers  

---

What is principle of ultrasonic level transmitter?

3 Answers  

---

calculate the rane of level use of this values, h=3 meter density=0.9 , whats the rang?

2 Answers  

---

what is the well head protection system?

1 Answers  

---

What is the SCAN time of a DCS/PLC? What is the typical value for scan time of DCS and PLC?

6 Answers   Essar, Gasco, Siemens,

---

what is novram ic number of foxboro 762cna microcontroller ?thank

1 Answers  

---

principle of dead weight tester ?

0 Answers  

---