Answer / manpreet.sodhi08

cycle time--

THE TIME TAKEN TO RETURN TO ITS STARTING POINT AFTER THE
COMPLETION OF ALL PROCESSES.

STANDARD TIME-

The time which should be followed by the all processes
during the completion of the cycle.

means cycle time should be closer to the STANDARD time.

CRITICAL STANDARD TIME--

Maximum time that can be used by the processes during its
complete cycle is called CRITICAL STANDARD TIME.

What do you understand by Newtonian Fluid? Where is it used?

0 Answers   Ashok Leyland,

---

1.what is the minimum percentage for engineering students? I like to become RTO officier...please send me procedure for that...

0 Answers  

---

High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What is a “proximity probe” used to measure?

0 Answers   Mobius, Tech Mahindra,

---

My Isuzu common rail 4Hl 1-1 tipper caught to flood & water absorb to engine through air intake line (air cleaner) then I put new pistons, rods everything its needed. But now when I start the engine its try to start with normal starting sound. I try to start until battery getting low, but nothing happen. What can I do? Please help me to resolve this problem.

1 Answers  

---

How bhp can be calculated in si units?

0 Answers  

---

WHY BIG TYRE USED IN REAR OF VEH?

4 Answers   Cummins, Escorts, Gmmco, HMT,

---

Why wheel type steerig is used in cars instead of hand steering used in auto-rickshaw?

0 Answers  

---

Double declutching is used for the engagement of gears in a) Sliding mesh type of gear box b) Constant mesh type of gear box c) Synchromesh type of gear box d) None of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---

What will happen if someone adds oil to the fuel of four stroke bike engine?

0 Answers  

---

Why the plastic materials used in the screwdriver's handles?

0 Answers  

---

What is back compressor in engine?

0 Answers  

---