Answer / praveen kumar s

petrol engine's compression ratio is 14.7:1....while
diesel's is 35:1... with petrol in diesel engine , it gets
compressed to 35 units...at this pressure petrol
explodes ....conclusion is tat engine will explode

Answer / nishan

see friends the answer is vv simple!!
if we use petrol in diesel engine the engine will continue
to fire till diesel is there due to the density difference
ie. petrol is lighter than diesel in density..
so after all the diesel has been used the engine will not
operate!!
similarly for petrol engine the engine will not fire when
diesel is poured because of the above reason!!

Answer / sugesh kumar

IF WE POUR DIESEL IN THE PETROL ENGINE - THE VOLTALITY OF
DIESEL IS HIGH AND FIRE POINT IS HIGH THAN THAT OF PETROL SO
THE ENGINE WILL NEVER STARTS
iF THE PETROL IS POURED IN DIESEL ENGINES THEN THERE WILL BE
HEAVY KNOCKING AND PRE-IGNITIN SINGE THE PETROL HAVE HIGH
VOLATILITY AND LESS FIRE POINT THAN DIESEL...THE ENGINE WILL
START

Answer / sameer

the petrol engine will not fire when diesel is poured
because petrol is lighter than diesel in density. so the
angine will not operate.

Answer / jijovijay

Petrol has greater knocking characteristics as compared to diesel. so if we using petrol in ci engine due to high temperature petrol will tends to knock. Because of that sufficient power will not producing inside the engine.

Answer / garrettpatton

This is very nice and really appreciating.
you can also visit <a href="http://www.smartlink.com/">site</a> for more information.

Answer / ankit

petrol is ignited by spark plug and diesel by injector so
when we add petrol in diesel engine it will not ignite
bacause the compression ratio of diesel is much higher than
petrol

Answer / ghanshyam singh

the petrol will not burn due to the absence of the spark plug

Answer / amit kumar sharma

petrol engine and diesel engine compresion ratio is
diffrent.the patrol is lighter and is density
effuncy.sothat result is diesel engine is fireing contnious

Answer / arjun

fuel is preignited due to the temp & compression

Is it mandatory to maintain RG Part 1 & 2 manually? Can we submit excel format of the same to excise dept?

0 Answers  

Stiff spring is used in the selector mechanism a) To prevent engagement of two gears simultaneously b) To prevent engagement of reverse gear c) To facilitate the gear selection d) To avoid the necessity of having neutral gear

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

What are the different alloys of brass?

0 Answers   Ashok Leyland,

how cdi unit works ? what will happen if there is no cdi unit in car?

0 Answers  

Define elastic limit and yield point.

0 Answers   Ashok Leyland,

The torque transmitted by a clutch is given by a) T = μWR b) T = μ/WR c) T = μW/R d) T = 1/μWR

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

automobile

2 Answers  

What happens if you use petrol in diesel engine?

0 Answers  

what is the three method of heat transfer?give example of each.

3 Answers  

Is boiler a closed system?

0 Answers   GM General Motors,

What is back compressor in engines?

0 Answers  

Single reduction is used in final drive when it is about a) 6:1 b) 8:1 c) 10:1 d) 12:1

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,