LT cable fault checking instrument is available? where and
how to get it.
Answers were Sorted based on User's Feedback
Answer / amit
For LT Cable fault location there is two type of method is used.
1)Prelocator --By this equipment you can prelocate the fault
i.e. there is +_2 to 3% error.
2)Thumper --By this equipment you can pin point the fault.
For more queries you can contact Mr. Amit Mehta (M/s PCI
Limited) Contact no.9820239725.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / venkatesh a
Use the Cable fault locator.
Make- Hung mung
Price- 18 lakhs
For more details see the web page
Is This Answer Correct ? | 0 Yes | 0 No |
difference between converter and invertor
How much ph is maintained of water resistance starter for slipring induction motor ?
What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.
suppose we using 3 phase motor of 440 v means what range of C.T. is require for measuring current , the rating of motor is 1HP ?
completed BE & done apprentice at tneb & having experience 6 years. want to get c license. will apprentiship & BE be helpful for getting c license. will i get any preference by showing this?
can any one provide some material?
how is motorized megger operate?
why any inductive load need free wheeling diode?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
what's burden resistor, why it's used?
what is under coal gassification?
Ceiling fan motor wiring Hi, I have 2 ceiling fans broken. The receiver/control units burned out due to lightening. One Harbor Breeze and one Hunter's I took them apart (remove receiver units). Now on both of the motor I see 4 wires coming out from each motor I really want to know the function of each wire. Are there anyway I can test to see which is which? After searching forums I know these 4 wires are from 2 sets of coils inside the motor, one is Start winding and the other is Runing winding I could not find the receiver/control unit any where, so I am planing to buy Capacitors and universal remote controls to make the fans run again. Anyone has any idea how to do the wiring, please help Thnks