Interested to Buy Any Domain ? << Click Here >> for more details...
LT cable fault checking instrument is available? where and
how to get it.
- 2 Answers
- 4390 Views
- I also Faced
- E-Mail Answers
Answer Posted / amit
For LT Cable fault location there is two type of method is used.
1)Prelocator --By this equipment you can prelocate the fault
i.e. there is +_2 to 3% error.
2)Thumper --By this equipment you can pin point the fault.
For more queries you can contact Mr. Amit Mehta (M/s PCI
Limited) Contact no.9820239725.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
what is smartµ grid technology?under coal gassification?
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
What is a parabolic signal?
How to test IR testing & magnetic balance test
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
TELL ME WHAT IS INDUCTOR AND CAPACITOR WHAT IS IT BASIC OPERATION ANDFUNCTION?
What is meant by sag?
What facility we get after CT secondary earthing and how?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
how to control dc motor?
