Dear all:
Recently we got a question about Interface between PMS
and SAP-PM.once we got a update message from PMS.we should
set the deletional flag for functional location in SAP
system.Is there any FM or BAPI to use?There are only
functional location create and change provided by SAP.
Best regards!
No Answer is Posted For this Question
Be the First to Post Answer
if the rotor of induction motor is purely inductive then what is the electromagnatic torque.........
Define stepper motor. What is the use of stepper motor?
how to calculate
What is electrical energy ,power?
Why Capacitor & ignator used in MH lamp
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
At what condition differential relay will act in transformer and ht motor?
For example, if I use Star delta transformer for distribution, Can I Connect 230 V lighting load bewteen secondary phase & primary neutarl. What will be the effect, if I connect in this manner?
How the over load setting for HT Motors calculated-provided in Numerical Relay
0 Answers Damodar Valley Corporation,
sir i have applied for isro-09. still i did not got the HALL TICKET.
What the reson for frequant instantaneous ground over current fault in our sync. Generator... 15 triping in 24 hr...
1 Answers HCPL, Jhunjhunwala Vanaspati Jhoola, Regen Powertech,
why the NGR (neutral grounding resistor) always OFF during DG off?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)