Answer / ankit trivedi

TO SELECT PROPER BUSBAR WE SHOULD KNOW THE LOAD CURRENT &
CROSS-SECTION AREA OF THE MATERIAL WHICH IS GOING TO BE
USED. IE CU OR AL.

I.e A CU. BUSBAR OF 25x6 Sq.mm. WILL CARRY THE CURRENT AS
BELOW

25X6 = 150 (cross section area)
150X1.6 =240A
THE BUS BAR OF 25X6mm. WILL CARRY 240A CURRENT, WHERE 1.6
IS GLOBLE SAFTY FACTOR.

Answer / a.mishra

For Cu Bus-bar:- 1.1 amps/sq.mm
For Al Bus-bar:- 0.6 amps/sq.mm

Can I parallel 1 MVA generator with 1kVA Generator? if V, F, Ph Seq and Ph angles are same

2 Answers  

---

what are the protections used in power transformers of 5 mva and above

2 Answers   ESRI,

---

WHY WE NEED NEUTRAL FOR 3PH 400 OR 415 VOLTS POWER SUPPLY (4 WIRE SOURCE).

5 Answers  

---

Electrical breakdown strength of an insulating material depends on............?why because?

2 Answers  

---

which type of insulation are used on 132kv transmission line

4 Answers  

---

Why servomotor and induction motor are in different shape

1 Answers  

---

What is the definition of ohms law?

7 Answers   AZ Engineering, Ecil,

---

What descriptive information does the NEC require to be marked on all conductors?

0 Answers  

---

what is use of substation? Any book on how to instal or construction of substations?

6 Answers   Siemens,

---

what is EBXl (electron beam cross linked ) cable ?

1 Answers   Polycab,

---

Dear all, Can anybody tell me that how to choose CT for a specific load? I have a 200kw induction motor, which ratio CT should be installed? Is there a formula or calculation that determines the CT ratio for a load? Regards.

2 Answers  

---

What is the name of powder which is used in inner side of a cable? and purpose?

1 Answers  

---