how to calculate load if i have three phase & single phase
connection from power transformer( in term of kw & kva).can
i take single phase load/3 for total kw calculation
Answer / c.s.padmanabhan
Adding total three phase KVA and total single phase KVA(without dividing by 3)will give net KVA demanded from the transformer.
Is This Answer Correct ? | 5 Yes | 1 No |
when i am going to take trail on a 3ph sq.i/m motor 5.5kw, i observed that RPM of the motor is very low as compared to the rated RPM and also it rotates in clockwise in first ON command,and anticlock wise in second ON command. finally i observed that on phase is no available . but iam not clear about, why the motor is rotates in both directions without any phase interchanging.pls answer to my question.
Off-circuit Tap changers in distribution transformer required
If one lamp connect between two phases it will glow or not?
Why should we use the igniter in the sodium vapour lamp.
7 Answers ABB, Delphi, Mudhra, NTPC, PICT,
what is the difference between E.L.C.B & R.C.C.B?
Frequency in the control system represents? Continuous system in time domain ? In frequency domain?
How do you calculate of power factor, if it is lagging or leading for unit(1).
what are pilot cells
Tell me about Simence PLC 'BLOCK'.How many types and what for.
Which type of alternator used in power station?
Difference between control junction box (cjb) and power junction box(pjb)?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .