HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH
CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH
BOARD,MLDB,ACB,BUSBAR,ETC...?
No Answer is Posted For this Question
Be the First to Post Answer
What is the difference between ground & earth or neutral
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
What is the out put of a CT? How the ratio is decided ?
Two 11 kv lines are feeding to common bus in a substation,I have one set of CT & PT(3ct,2pt), How can I measure both lines power using single set.
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
why are the transmission lines operated at 220 kv nly... nt les dan dat...
what is meant by mimic diagram ?where it is used ?plz explain briefly
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
losses in transmission lines ?
how a generating station can monitor its multi users power factor. What type of incentive /penalty is associated with power factor management.
what is vector surge & vector shift? we have 25.3 MW(11kv) generator & 11kv/132kv transformer, connected with with 132 kv grid.vector surge relay is tripping frequentaly.what is permissible maximum limit for this.
condition Autotrip facia come on control panel of electrical transmission line?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)