what is the transmission loss for electrical supply?
specifically a large shopping complex where the grid is
half KM away, what will the % of transmission loss? is
there any transmission loss for captive unit generation for
above set?
thanks
No Answer is Posted For this Question
Be the First to Post Answer
What are the tests to be done on circuit breaker?
what the Microsoft .NET framework is?
What are the properties of a resistor?
What core magnetic balance test of transformer? How to do this test in a three phase Star star (star-LV, star-HV) transformer? How to measure and where to measure?
What is the difference between MCCB & ACB Where it can be used
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
Tell me harmfull effects of over voltage,under voltage,spike,surge,transient & noise.
What is the working principle of servo motor? And explain it.
what is the difference between LLL and LLLG fault ?
In power point wiring,often,we use less size of earth wire compared to phase & neutral wire and we use big size pin in pug top. how is it justified? can we use small size cable for earthing?
What is differance betwwen Conventional MCC & Inteligent MCC?
where this neutral connection goes after returning from the load(home ,factory,industries).Is it grounded at the transformer side or atthe generator side .If it is grounded then we also ground the earth connection.is there any problem with this.
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)