in engine when the engine stops are the pistons were stopped in between or the

Categories >> Engineering >> Mechanical Engineering
Suggest New Category

in engine when the engine stops are the pistons were
stopped in between or they complete the process.

Question Posted / ajay

6 Answers
14726 Views
Honda, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

in engine when the engine stops are the pistons were stopped in between or they complete the proce..

Answer / baskaran.r

when engine is stopped, the pistons may be at varies
positions like TDC, BDC, or in the middle.

Is This Answer Correct ?

14 Yes

3 No

in engine when the engine stops are the pistons were stopped in between or they complete the proce..

Answer / maria ambroseraj

it depents upon the size of the flywheel.main thing is
compretion stoke offer more opposition for piston, so the
piston will stop at the starting of compresion stoke or
middle of compretion stroke . if the fly wheel is big,
piston will overcome 1 or 2 compretion stoke also. friction
also matters.

Is This Answer Correct ?

12 Yes

3 No

in engine when the engine stops are the pistons were stopped in between or they complete the proce..

Answer / arun prasath.b

when piston complete the process

Is This Answer Correct ?

12 Yes

7 No

in engine when the engine stops are the pistons were stopped in between or they complete the proce..

Answer / srikanta kumar pattnaik

after complete the the process

Is This Answer Correct ?

10 Yes

5 No

in engine when the engine stops are the pistons were stopped in between or they complete the proce..

Answer / richa sachdeva

the pisyon can stop anywhere in between, it is not
neccessary that it will stop only when it is at TDC or BDC

Is This Answer Correct ?

5 Yes

1 No

in engine when the engine stops are the pistons were stopped in between or they complete the proce..

Answer / guest

piston is complite the process.

Is This Answer Correct ?

1 Yes

7 No

Post New Answer

More Mechanical Engineering Interview Questions

a 20ph motor runnig a load with direct belts, can we use 10hp motor for the same load with the help of gear where motor rpm 900 and load rpm 250

1 Answers

difference between pipe and tube

16 Answers

Why water treatment is required for boiler feed water?

3 Answers

List the different devices and components of main switchboard.

0 Answers RRB,

What causes damage to impellers?

1 Answers

what can be the technical questions for the post of a design engineer?

6 Answers

i have 3sge type g rav 4 1997 can i modyfied my engine to dual vvti 3sge

1 Answers Jaypee, Toyota,

I have 1010 KVA Generator when i run the DG set for 5 to 6 hours the couplling (couplling joint in between engine & alternator) bolts are getting loose what is the reason & what is the remedy over this??????????

7 Answers

how control valve works? process line pressure is 50kg/cm2g and instrument air pressure is about 4 kg/cm2g.

0 Answers

Which is more Elastic Steel or rubber? Plz give the reason also........ mchandan86@gmail.com

18 Answers

what is the material composition in IBR tubes?

5 Answers Thermax,

what is mean by mmwc?

1 Answers

For more Mechanical Engineering Interview Questions Click Here