Answer / sornakumar

in petrol engine compression ratio is low so it makes more
detonation.if we use this in heavy purpose it lead to low
efficiency and damage the component.in detonation
compression ratio decrese it ill increase.

Answer / anjaney k. kulkarni

compression ratio<10 due to knocking factor. if C.R
increases,detonation increases. for heavy purpose heavy
power is required and with C.R<10,size of engine will
increase which is not economical as compared to diesel
engine. its power to wt ratio will be less.

Answer / bhaskar

generally petrol engines has constant volume cycle heat
addition so that the engine is not designed to deliver
torque from flywheel but more speed.

Answer / pankaj singh

bcs compression ratio of the petrol engine is low and it
produce more detonation. suppose we are using petron engin
in haevy perpose it decrease the effecency & damge the
engine part & increases the chance of detonation that's why
we can't use petrol engin in heavy perpose.

Answer / krishna

due to the high operating cost.power generated by disel
engine is high and also load carrying capacity is high in
disel engine.

Corundum mainly Contains__________

1 Answers   Behr, Bhel,

Any one please sent me a mahindra tractors model question papers.

0 Answers  

Would you be able to join our organization in a month"s time?

0 Answers  

When looking at a flanged extension pipe and it is labeled DN20, just what does that mean or intel?

0 Answers  

which kind of force act when the piston slides inside the cylinder?and how to calculate that force or stress theoritically.

4 Answers  

What is the importance of thermostat in the cooling system of an engine?

0 Answers  

what is the minimum height at which safety belts are mandatory as per safety rules?

9 Answers  

Do you work for many hours each day?

0 Answers  

Advantage of hollow shaft over the solid shaft

3 Answers  

What is function of steam strainer?

2 Answers  

We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?

0 Answers   PetroVietnam,

Explain the applications of ferrite material?

0 Answers