wht factor are considered to design ACB( air Circuit reaker) 415V

wht factor are considered to design ACB( air Circuit reaker)
415V

Question Posted / snr3032

3 Answers
6876 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

wht factor are considered to design ACB( air Circuit reaker) 415V..

Answer / har

making capacity
breaking capacity
short circuit capacity & time

Is This Answer Correct ?

11 Yes

1 No

wht factor are considered to design ACB( air Circuit reaker) 415V..

Answer / prashant pate

current rating,duty (indoor/outdoor),protections needed,
control voltage,switching mechanism,cost,Switching arcs etc.

Is This Answer Correct ?

2 Yes

3 No

wht factor are considered to design ACB( air Circuit reaker) 415V..

Answer / srinivasa rao talasila

Making capacity,Breaking capacity,Earth fault and short
circuit,Time and Impulse current rating

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

draw singleline diagram of star to delta and dol starters

0 Answers JCP,

1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.

0 Answers ABC,

How do you reverse the direction of rotation of a FAN?

13 Answers CPCL, IOCL,

What are the advantages and disadvantages of open loop control system?

0 Answers

What is the Working principle of ELCB and RCCB?

1 Answers Geo Miler, L&T,

which VFD is better ( LT or HT)

0 Answers

A 6-pole, 50 Hz, 3-phase synchronous motor and on 8-pole, 50 Hz, 3-phase slip-ring induction motor are mechanically coupled and operate on the same 3-phase, 50 Hz supply. If they are left open-circuited, then the frequency of the voltage produced across any two slip rings would be

2 Answers L&T,

examples of resistive inductive and capacitive load

1 Answers

Tesla is the unit of which parameter?

4 Answers Ecil,

5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch

0 Answers

Why Neutral Isolation is required?

0 Answers

How can we convert dc to equivalent ac??

4 Answers

For more Electrical Engineering Interview Questions Click Here