Answer / ravi

Electric wiring on cleats or insulated supports which are
mounted on a wall or other surface, leaving the wiring
exposed; conduits or raceways are not used.

Thw Cleat Wiring is most widely used for tempor. Wiring
Systems..

Answer / hbk

cleat wiring is basically used in earl day, it cleats the
wire after evry unit measurement on pattern n exposed the
remaining part of the wire

How to calculate Earth busbar size & what is the procedure we make for determine that?

1 Answers  

---

what could be the RMS value and average value of a 4 phase sine wave?

0 Answers   BARC,

---

what is the differance beetwen installation and errection ?

1 Answers  

---

i asked a funny question in Electrical ohms law V=IR in const temp voltage is directly proportional to current Power p=VI cos@ in that formula Voltage is indirectly proportional to current Try to give me the fact what is happening in Electrical.. contact Thanigai_1984@yahoo.co.in

3 Answers  

---

block diagram of 2 ups system connected in parallel mode?

0 Answers  

---

what is tan delta measurement?..... why that terminal is earthed.....?

4 Answers   Power Grid,

---

What is the Surge suppresor? Why using in a UDB's and How it works?

0 Answers  

---

How much water ( Kilo Liters) a submercible pump of 35 HP can lift from Borewell of 6" and 900 feet dip.

2 Answers  

---

What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.

0 Answers   AES,

---

if two transformers are parallel & both have fault short ckt. impedance of 50KA in each case will it increase or decrease show example?

1 Answers  

---

how is the connection of a 3 phase ct trivector meter done on a pole mounted transformer

0 Answers  

---

Starting current of a 10 HP induction Motor is ______ time’s full load current.

0 Answers  

---