Answer / shahin

The command we have to configure on interface is

Router#clear counters serial 0

Sequence and acknowledgement numbers are used for? A.) Layer transitioning B.) Flow control C.) Port number addressing D.) Reliability

2 Answers  

---

Which statement is true regarding half duplex? A.) Only works in a point-to-point configuration B.) Allows for transmitting and receiving but not a the same time C.) Allow for transmitting and receiving of data simultaneously D.) Doubles the bandwidth

1 Answers  

---

Which dynamic type draw back is, if single link down, it removes its routing table?

0 Answers  

---

Which is true regarding store-and-forward switching method? A.) Latency varies depending on frame-length B.) Latency is constant C.) It is default for all Cisco switches D.) It only reads the destination hardware address before forwarding the frame

1 Answers  

---

Define the virtual path?

0 Answers  

---

Identify the command to configure DLCI 100 on an interface e0? A.) Router(config)# frame-relay local-dlci 100 B.) Router(config)# frame-relay local-dlci 100 int e0 C.) Router(config-if)# frame-relay local-dlci 100 D.) Router(config-if)# frame-relay local-dlci 100 int e0

1 Answers  

---

Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecing to non-Cisco equipment C.) You must use Q.933a encapsulation if connecing to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment

1 Answers  

---

What is the default interval for SAP updates? A.) 60 seconds B.) 15 seconds C.) 30 seconds D.) 120 seconds

1 Answers   ACS,

---

Which two steps are required to confound and apply standard access lists on an interface? (Choose two) A. define an access list number and its parameters B. enable an interface to become part of the access list group C. define the number of access lists to be supported on an interface D. copy the access list definition to each interface that will support it

2 Answers  

---

What is the difference among straight cable, cross cable and rollover cable?

0 Answers  

---

Which command line option will determine what traffic is interesting enough to establish a dialup connection? A.) dialer map B.) dialer string C.) dialer in-band D.) dialer-list E.) dialer negotiation

1 Answers  

---

WHAT IS RIP PROTOCAL ?

3 Answers   NIC,

---