Interested to Buy Any Domain ? << Click Here >> for more details...
whats the routing protocol supporting in both juniper ,
cisco routers.
- 10 Answers
- 14209 Views
- HCL, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / ccie-sec
frnds any open stnd. routing protocol support in all vendors...
Static, Rip, Ospf, BGP, IS-IS....hope u can understand..
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / jitendera
hhahaha Keep trying if i am saying Static am i wrong ?
please rate
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / nikhil
The Two protocols would be OSPF and BGP and they are Industry Standard Protocols.
MPLS is NOT a Routing Protocol.
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / s...
Jitu Bhaiya..... Mahan hai.. aap kaise galat ho sakte hai.
Aap k shub chintak...
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / chinna
Mpls is the only protocol speak between juniper and cisco
| Is This Answer Correct ? | 2 Yes | 3 No |
What must be true for two Routers running IGRP to communicate their routes? A.) Same autonomous system number B.) Connected using Ethernet only C.) Use composite metric D)Configured for PPP
Identify the command that disables name-to-address translation? A.) Router(config-dns)# no ip domain-lookup B.) Router(config)# no address translation C.) Router(config)# no ip domain-lookup D.) Router(config)# ip domain-lookup
How we can find ASBR Router, we have no authentication to enter router?
Explain types of communication in ipv4?
Define the igp (interior gateway protocol)?
What is a vlan?
Can Anybody tell me if I wanna block all MP3,video sites from cisco 2600 router,how shall i proceed with ACL's?? Please post the steps for the following alonge with detail. Thanks to you all ..appriciated
Which Standard IP Access list commands will deny only the source address 1.1.1.1? A.) access-list 9 deny host 1.1.1.1 B.) access-list 9 deny 1.1.1.1 255.255.255.0 C.) access-list 9 deny 1.1.1.1 0.0.0.0 D.) access-list 9 deny 1.1.1.1 0.255.255.255 E.) access-list 9 deny 1.1.1.1 255.255.255.255
Of the following, which reason applies to dividing a large network into two or more smaller networks? Performance Security Address Management All of the above
What would be the first command from global configuration mode to enable RIP on your router for interface E0, with an address of 181.86.4.4 and mask of 255.255.255.0 ? A.) router rip B.) network 181.89.4.0 255.255.255.0 C.) router rip int e0 D.) router rip 181.86.0.0 E.) router rip 181.86.4.0 F.) network 181.86.0.0
Identify the command to configure ALL the default VTY ports? A.) Router(config)# line vty 0 4 B.) Router# line vty 0 4 C.) Router(config)# line vty D.) Router(config)# line vty 0
What is HDLC?
CCNA 
