What is ping used for?

0 Answers  

---

The Datalink Layer is broken down into 2 layers, LLC and MAC. The LLC establishes media independence and what else? A.) Provides Windowing. B.) Provides flow control. C.) Provides SAP's (Service Access Points). D.) The Datalink layer does not have sublayers. E.) Provides SAP's (Service Advertising Protocol). F.) RIP Updates.

2 Answers  

---

When discussing static routes, what is the gateway parameter used for? A.) Determining the dynamic route B.) Defining the subnet C.) Defining the Administrative Distance D.) Determining the next hop

1 Answers  

---

You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router

3 Answers   TCS,

---

What command can be used to test IPX connectivity? A.) Ping 2e.000.0045.8923 B.) Ping 192.168.100.1 C.) Ping ipx 2e.0000.0045.8923 D.) Ipx ping 2e.0000.0045.8923

4 Answers  

---

Which three tasks are required to confound a dial on demand routing (DDR) Basic Rate Interface (BRI) connection? (Choose three) A. define static routes B. confound the abler information C. specify the interesting franc that can enable the link D. define a DDR password to exchange when the link comes up

1 Answers  

---

Which frame has a Type field to identify the upper-layer protocol? A.) 802.3 B.) 802.2 C.) 802.5 D.) Ethernet_II

1 Answers  

---

Choose three reasons why the networking industry uses a layered model: A.) It facilitates systematic troubleshooting B.) It allows changes in one layer to occur without changing other layers C.) It allows changes to occur in all layers when changing one protocol D.) It clarifies how to do it rather than what general function to be done E.) It clarifies what general function is to be done rather than how to do it

1 Answers  

---

Which of the following are used by routers to learn routes to be added to the routing table? Ping and Traceroute MAC address resolution Acknowledgments and Sequence Numbers Routing updates and static routes

1 Answers  

---

Which protocol gets a hardware address from a known IP address? A.) RARP B.) TCP C.) IP D.) BootP E.) ARP F.) ICMP

2 Answers  

---

When configuring the subnet mask for an IP address, which formats can be used?A. dotted-decimal. B. Hexadecimal C. Bit-count D. Octal E. Binary

1 Answers  

---

Eight stations connected to separate 10 Mobs pods on a Layer 2 switch will give each station how many Mobs of bandwidth? A. 1.25 B. 4 C. 16 D. 10 E. 80

1 Answers  

---