In which two modes can the ICMP ping command be used?
(Choose two)
A. user
B. privileged
C. global configuration
D. interface configuration
- 1 Answers
- 4804 Views
- I also Faced
- E-Mail Answers
What utility can you use to see the path a packet takes through an internetwork? A.) Route B.) SNMP C.) Trace D.) Ping
What is protocol data unit in ccna?
When you enter router passwords during the setup dialog what is the difference between enable and the enable secret passwords? A. The enable password is encrypted B. The enable secret password uses IPSec password authentication C. The enable secret password cannot be seen as clear text when viewing the configuration D. The enable secret password acts as a backup in case the enable password is compromised
What would be the first command from global configuration mode to enable RIP on your router for interface E0, with an address of 181.86.4.4 and mask of 255.255.255.0 ? A.) router rip B.) network 181.89.4.0 255.255.255.0 C.) router rip int e0 D.) router rip 181.86.0.0 E.) router rip 181.86.4.0 F.) network 181.86.0.0
Identify 3 characteristics regarding IP access-lists? A.) Can be configured as a standard access-list B.) Can be run from another router running IP C.) Can be configured as a named access-list D.) Are the same as IPX access-lists E.) Can be configured as an extended access-list
Hi -All Can you tell me About of NAt (Network Address Tranlator) bcoz i have no idea about this topics Such as local ip , global ip and all plz provide the deatil of this topics
What is the minimum request timer?
A company running RIP V1 protocol on their 2 seperate networks, each nw has 14 routers, if the two nw wants to be merged with each other total no of routers will be 28. but rip metric is hop count(15). What needs to be done if this setup needs to be work ?
What is difference between Store-and-Forward, cut-through, Fragment-Free Method?
Identify the command to configure the IP address 172.16.100.5 255.255.255.0? A.) Router(config-if)# ip address 172.16.100.5 255.255.255.0 B.) Router(config)# ip address 172.16.100.5 C.) Router# ip address 172.16.100.5 255.255.255.0 D.) Router(config)# ip address 172.16.100.5 255.255.255.0
Can yo define LNS
What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.
CCNA 
