Answer / nabhnish

Phase advancer is also used for power factor improvement.

Answer / deepa.v

total power generation is 8500MW.Demand-11,500 t0 12,500MW
to improve power factor-using capacitors,synchronous
condensers

Answer / harikrishnan

total power generation is 17536MW .while state require
10257Mw but because industries acquire with central
government more power is consumed so tamil nadu gets 8850 MW
of power which is about 11% less what required

Answer / a.mujibur rahman

total power generation of tamil nadu around 15000mw.
we can use shunt capacitance,condenser,etc for improve pf.
above 750kv using dc transmission due to reduesing the loss.

Answer / senthil kumar

Nlc,solar,wind ,tide.

during parallel operation of two ac generator which condition must match before taking both parallel i.e speed /voltage rating /kva/exciation

2 Answers  

HOW TO MEASURE AC VOLTAGE BY USING GALVANOMETER?

1 Answers  

a 11 kv line is grounded and a 110 kv line is grounded. which line have the greater current flow?

4 Answers  

please design a rectifier with batteries for below requirement and also explain how you calculate this solution, Load = 700Amp DC Backup time = 6 hour. please explain briefly ?????

1 Answers   GNFC,

working principle of generators?

4 Answers   Adani, MahaGenco,

What is an alternator impedance value?

0 Answers   Orchid,

diffrence between windings of high tension side and low tension side of transformer

1 Answers  

I want to know if it is possible to use Variable Frequency Drive to reduce the current required for starting a motor?

3 Answers   Descon,

what is the minimum dielectric stregth of transformer oil.

25 Answers   HP,

In an LT pole, the line voltage is 415V. How is it converted to 230V into the house via the service cable?

10 Answers  

why capacitor takes more current

4 Answers  

any idea abt REVERSE METERING concept.........?

0 Answers