WHAT DO U MEAN BY THERMAL OVER LOAD RELAY& WHERE THEY ARE
BUSED
Answers were Sorted based on User's Feedback
Answer / suresh
on bimetalik strips will be bend one side when heat
devloped and it will be orderd to break the control ckt
its used in motor staters
Is This Answer Correct ? | 18 Yes | 2 No |
Answer / senthilkumar
What Mr.Suresh mentioned is correct. Only thing is
bimetalik strip starts bend only the load current exceeds
OLR set value.
Is This Answer Correct ? | 7 Yes | 1 No |
Answer / venkatesan.j
Thermal over load relay consists of bimetallic strip made
up of two metals one having high co-efficient of expansion
and the other metal having low co -efficient of
expansion ,such that when heated up the strip starts
bending . The soource of heat is provided by the load
current in the strip.
Is This Answer Correct ? | 3 Yes | 0 No |
all 3 current transformers (C.T) are burnt in a L.T Panel - what are the possible reasons
what is the difference between general inverter and solor inverter clerly explain plz
Why we use a shunt capacitor or synchronizing Motor To Improve a Power factor pls reply me in this mail dinesh_elect_eng@yahoo.com
can we load Power capicitors on DG sets?
14 Answers Neptune, Nimbus, Westin,
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
IF we have 500kva transformer 11.0/0.415V, 50Hz. How to calculate the current on HT & LT side, how can we consider for its breaker (HT & LT both)? You are requested to solve the question herewith.
3 Answers Bhutan Power Corporation,
Is it posssible to obtain the higher speed(3000rpm) for adiferentiallly cascaded induction motors(with 8 and 6 poles)
wich type of cable is selected for wiring of 20hp motor?
why threre are two parallel lines in transformer's symbol?
The following equipment are installed ia a plant 1. 110KW Induction motor 4 Nos 2. 30 HP motor 3 Nos 3 15 HP Motor 3 Nos 4 7.5 HP motor 4 Nos what is total load of plant if one of each is stand by.
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
what is the principle to generate energy from water or coal, plz define the step by step how & when electricity energy start from resource area to ours home meter & separate & how meter read the voltage or current?