Answer / rajesh

Actually the type of flux produced in the rotor after
giving excitation (dc current)is constant.then the rotot
will be rotated by a Motor or turbine will cause emf
induced inthe rotor. if we give ac current to the rotor the
flux is variabe and cause emf induced in the stator and
start it will act as a motor. but we are forcely rotating
roator by turbine the rate of change of flux will be
zero.so that there is no emf will induce.

If excitation will increase, then what will be the effect on power factor? Will it decrease or increase?

4 Answers   Prozone,

---

What is the difference between relays and contactor construction wise?

0 Answers  

---

while grounding the galvenized metallic structures is it necessary to remove the galvenization at the point of contact? Or other wise is the galvenizatio a good conductor?

1 Answers  

---

why not feeling shock while touching rotor shaft of induction motor during running condition? during running condition emf induced in rotor.

1 Answers  

---

What is various types of electrical formula?

1 Answers  

---

15 kva dg set single phase takes 63amp( approximate) while same rating 15kva three phase takes 35amp approximate. why ? and what will be per phase current for 15 kva

2 Answers   TVI,

---

what is difference between neutral and ground wire?

2 Answers   TCS,

---

HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)

0 Answers  

---

what is short circuit force ? How to calculate it for Panel?

1 Answers   Bilt,

---

A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N

0 Answers  

---

HOW BETTER VOLTAGE REGULATION IS OBTAINED BY HIGH VOLTAGE TRANSMISSION....?

1 Answers   Cummins,

---

how to calculate cable size with respect kw

0 Answers   SPMI,

---