Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen if ac power supply is given to the rotor
of an alternator
- 1 Answers
- 9036 Views
- Goldman Sachs, I also Faced
- E-Mail Answers
Answer Posted / rajesh
Actually the type of flux produced in the rotor after
giving excitation (dc current)is constant.then the rotot
will be rotated by a Motor or turbine will cause emf
induced inthe rotor. if we give ac current to the rotor the
flux is variabe and cause emf induced in the stator and
start it will act as a motor. but we are forcely rotating
roator by turbine the rate of change of flux will be
zero.so that there is no emf will induce.
| Is This Answer Correct ? | 12 Yes | 16 No |
Post New Answer View All Answers
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
How to select HT/MV cable size ?
What is the reason that the humming sound is coming from the induction furnace panel?
why co incidence factor considered in transformer sizing?
How do you determine the size of transformer radiators in a transformer?
What is core CT & it's function?
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
What is oscillator circuit?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
Work done in a free expansion process is
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
What is the equivalent circuit of a transformer and its vector diagram?
