while trouble shooting a network conectivty prob a
technician observes that steady link light on the both work
stations nic and the switch port which the workstation is
conected.however when the ping comand is issuede from the
work station the out message is request time out
at which layer of osi model does the prob most likly exist
1 sessiom layer
protocol layer
datalink kayer
acess layer
network layer
application layer
i have ansered n/w layer but i am niot sure
i have also posted privous question
jitendera kumar sinha
- 3 Answers
- 5413 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / jitendera sinha
dear ketan
can you expalin your answer becoz networlayer is wright one
but i did not get the wright eplanation
| Is This Answer Correct ? | 0 Yes | 0 No |
What is the default encapsulation of Netware 3.12? A.) Ethernet_II B.) 802.5 C.) 802.2 D.) 802.3
Identify the command to determine if an IP access-list is grouped on interface e0? A.) Router(config)# show ip interface e0 B.) Router> show ip interface e0 C.) Router# show interface e0 D.) Router# show ip interface e0
What is CSU/DSU & explain the function????
Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses
Which OSI Reference Layer controls application to application communication? A.) Datalink B.) Network C.) Transport D.) Session E.) Physical
Which layer allows multiple Ethernet devices to uniquely identify one another on the Datalink layer? A.) Transport B.) Session C.) Network D.) Datalink - MAC Sublayer E.) Datalink - LLC Sublayer
When configuring the subnet mask for an IP address, which formats can be used?A. dotted-decimal. B. Hexadecimal C. Bit-count D. Octal E. Binary
The Cisco Discovery Protocol (CDP) periodically sends out a multicast packet (at layer 2). Which command will alter the default interval of 60 seconds? A.) cdp hold 111 B.) cdp wait 111 C.) cdp interval 111 D.) cdp 111 E.) cdp timer 111
I want to configure a serial interface on a 7500 with a VIP card. What global config command would give me access to a serial interface on a 7500? A.) int 1/0/0 B.) int s 1/0/0 C.) int s 1/1 D.) int s0.1 E.) int s1
what is meant by domain ? what is mean by DNS?
What is the command for change serial cost?
Put the following steps of encapsulation into the correct order: 1) The data is broken into segments to be organized 2) Frames are converted to 1s and 0s to be put on the wire 3) Packets are converted into frames 4) Information that users enter is converted into data 5) The segments are changed to packets to be routed A.) 4, 1, 3, 2, 5 B.) 4, 5, 1, 3, 2 C.) 2, 3, 1, 4, 5 D.) 4, 1, 5, 3, 2
CCNA 
