Interested to Buy Any Domain ? << Click Here >> for more details...
Which layer allows multiple Ethernet devices to uniquely
identify
one another on the Datalink layer?
A.) Transport
B.) Session
C.) Network
D.) Datalink - MAC Sublayer
E.) Datalink - LLC Sublayer
- 3 Answers
- 6461 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: D
Ethernet MAC addresses are 48 bits long, and provide a
unique hardware
identifier.
| Is This Answer Correct ? | 3 Yes | 0 No |
Define autonomous system (as)?
Identify the administrative distance and appropriate routing protocol? A.) RIP = 255, IGRP = 100 B.) RIP = 100, IGRP = 120 C.) RIP = 1, IGRP = 0 D.) RIP = 120, IGRP = 100
here is your question sahin Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP. I knew about it from ICND 2 cisco press book. Three more questions - a) If we change the K value (I mean metric weight)on a router what will happen??? b) When redistribution is necessary in EIGRP. Is there any condition for that??? c) What is reference bandwidth for metric calculation in EIGRP. As we know, in OSPF, on a CISCO router reference bandwidth is 10Mbps.
Identify 2 PPP characteristics? A.) Is proprietary to Cisco B.) Supports authentication C.) Support compression D.) Run on a multi-access network
Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom
Explain what are partial updates?
In which layer switch is work?
In port based access-list which command you give instead of ip?
When written <cr > what does it mean?
Which one is the Best protocol- Static routing, RIPV2,EIGRP,OSPF.
20 Answers EIGRP, HP, Tech Mahindra, Wipro,
What parameter is used with statically assigned routers to tell packets which interface to use to reach a distant network? A.) Mask B.) Subnet C.) Default gateway D.) Interface
Identify the command that disables name-to-address translation? A.) Router(config-dns)# no ip domain-lookup B.) Router(config)# no address translation C.) Router(config)# no ip domain-lookup D.) Router(config)# ip domain-lookup
CCNA 
