Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the command to determine if an IP access-list is
grouped
on interface e0?
A.) Router(config)# show ip interface e0
B.) Router> show ip interface e0
C.) Router# show interface e0
D.) Router# show ip interface e0
- 1 Answers
- 5115 Views
- I also Faced
- E-Mail Answers
Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share
Difference between Distance vector, Link state protocols
What is the command to copy the IOS image to a TFTP server? A.) copy flash tftp B.) copy running-config tftp C.) copy ios tftp D.) copy startup-config tftp
Identify the 2 methods to modify the routers boot sequence? A.) Setup program B.) Boot system commands C.) RXBoot D.) Config-register
Explain the difference between bus topology and hub?
Explain what is eigrp?
What we called 64 bit mac-address in ipv6?
The command 'debug ip rip' will do which of the following? A.) Show Neighbor Info. B.) Display RIP routing updates. C.) Show routing table changes. D.) Show all IP traffic. E.) This is not a valid router command. F.) Cause the router to respond with 'Ambiguous command'
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
What does protocol mean?
What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1
We have one router,we r using two routing protocol eigrp 90 net 1.1.1.0/16, ospf 110 net 1.1.1.0/24 on same router, Is it possible?
CCNA 
