Answer / amit biswas

general kW Vs Voltage ternd for motors as as follows
upto 250 Kw -414V
250-450 Kw-3.3 KV
above 450 Kw-6.6 KV

anyways these standrds can be avoided but this will affect
the size of motor.eg.a 250kV motor rated at 6.6 Kv will be
smaller in size thanat 3.3KV

l&t switch FN 63 handle position can we change

0 Answers   OPTCL,

---

Why use prefer Dc drive in place of Ac drive for kiln Operatio in Cement Plant?

4 Answers   Orient,

---

If the load of transformer is getting more than its rating,,,than how to overcome this problem? Suppose thee rating of transformer is 315kva and the load is going beyond than the rating say around load: 352kva... Than how can we solve this problem without deducting the load.

14 Answers   Hyundai,

---

Why short ckt does not happen when solenoid coil connected to supply. as its a wire only.

1 Answers   Siemens,

---

our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.

0 Answers  

---

How phase displacement change in the over current relay coils.

0 Answers  

---

Difference between SHORT CIRCUIT and an OVERLOAD ?

1 Answers  

---

What is lc oscillator?

0 Answers  

---

what are the different pre- commissioning tests performed on distribution transformer, power cable and switchgear?????

1 Answers   Reliance,

---

how to calculate the ac and dc wire losses with calculations plz tell me

3 Answers   Apollo,

---

If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..

0 Answers   Bhel,

---

WHAT MEANT BY SEVICE FACTOR?

2 Answers  

---