Dear Sirs, I am a technical persons.In one of our Electrical Sub- Station, We have installed three numbers of 1250KVA ,11KV/0.415KV Transformer to feed the Factory load. We have found some abnormality. In one of our Transformers the leakeage current from transformer body to earth through earth continuity wire is almost 86 Amp but in other transformer it is (5-10)Amp. where the load current on three phase and neutral are respectively 1360Amp,1400Amp,1370 Amp & 176Amp. So please any technical person help me about the reasons of this situation and how I can rectify the fault. Moreover,I have measured the earth resistance of the Earth continuity wire which is less than 1 Ohm. Thanks Tapas Barua

3 Answers  

---

single phase power supply give to separate one steel coup with water, what reaction create

0 Answers   Turbo,

---

What are the effects of adding a zero to a system?

0 Answers  

---

wat is meant by PX class in ct?

0 Answers  

---

why stator winding of synchronous machine are connected in star connection ?

1 Answers  

---

hi i am aziz electrical associate engineer. i am faceing problem in acs800 vvvf drive.it is tripping wothout any alarm/fault.i cheaked all parameters and fault function of drive, all are correct as well as communication parameters.but still it is tripping (drive is tripping in running position not in starting)

1 Answers  

---

how do u calculate CT rating for 10 mva transformer

2 Answers   Enercon,

---

What is the differance between negative dc voltage and positive dc voltage because some circuit uses -24,-5,-12,- 15,volt dc supply

10 Answers   eLab, Hero Honda, NTPC, Suzlon, Teradyne,

---

Which type of control system is expensive — closed loop or open loop?

1 Answers   GE,

---

A low wet bulb temperature indicates

0 Answers   Caterpillar,

---

why we use tapechanger in primary side of transformer

5 Answers   Bhel, L&T,

---

Can a generator runs after getting 1st stator earth fault.

0 Answers  

---