How Hydrulic Power Stering & Clutch works plz
explain?????????????????
Answers were Sorted based on User's Feedback
Answer / manoj prabahar
The power steering is actually power assisted steering. When
the steering wheel is turned towards some direction, the
hydraulic fluid will be pressurized ultimately moving the
lever connected to the wheel at some additional force,
reducing the the load given through the steering wheel so
giving stress free driving comfort while taking a turn.
Clutch is of different types and the basic principle is the
friction. when the vehicle is at motion the clutch is
engaged that means the friction surfaces engage. This
friction surface is the clutch plate also if number of
plates increase then the performance of the clutch also
increases, if you apply clutch the clutch lever dis engages
the frictions surfaces. so finally the engine power is not
taken to the transmission, so engine runs freely.
| Is This Answer Correct ? | 9 Yes | 1 No |
Answer / karthick
power steering concept is mainly introduced to optimize the
steering ratio.steering ratio means ratio of how much
degree you turn the wheel to the wheel turns.so instead of
using rack and pinion,we use power steering.here a
pump,valve is used.pump is driven by the engine and valve
is used to regulate the pressure.while the pump runs it
increases the fluid pressure this pressurized fluid assists
in steering the wheels
| Is This Answer Correct ? | 4 Yes | 6 No |
Name the common carpentry tools?
What will happen when engine stays in critical speed of 58-65 RPM?
Identify the parts of indicator diagram?
What is the percentage of carbon in cast iron ?
What will happen if oil is mixed with boiler feed water?
What instrument in a car measures its speed?
Can metal vapour converted to solid metal
What are mechanical safeties in DG sets?
I am Sunny..I have completed B.Tech(Mechanical).can i apply for Probationary Officer Post in Syndicate Bank 2010.Is that they hire engineers for PO Post?
what is the main differance betn id & fd fan
In order to ensure constant pressure and constant flow rate of compressed air what should we put between the compressor and end user?
On what basis can sliding contact bearings be classified? Explain?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)