Interested to Buy Any Domain ? << Click Here >> for more details...
How Hydrulic Power Stering & Clutch works plz
explain?????????????????
- 2 Answers
- 7566 Views
- I also Faced
- E-Mail Answers
Answer Posted / manoj prabahar
The power steering is actually power assisted steering. When
the steering wheel is turned towards some direction, the
hydraulic fluid will be pressurized ultimately moving the
lever connected to the wheel at some additional force,
reducing the the load given through the steering wheel so
giving stress free driving comfort while taking a turn.
Clutch is of different types and the basic principle is the
friction. when the vehicle is at motion the clutch is
engaged that means the friction surfaces engage. This
friction surface is the clutch plate also if number of
plates increase then the performance of the clutch also
increases, if you apply clutch the clutch lever dis engages
the frictions surfaces. so finally the engine power is not
taken to the transmission, so engine runs freely.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
why we do not megger to motor under system is very high vaccum condition. and what is the tempreture of vaccum conditon
Why PWHT IS NOT DONE TO STAINLESS STEEL MATERIAL?
What do you mean by annealing?
The lowest allowable insulation resistance?
Sir can u send me few interview questions and answers based on Deputy Superintendent(materials) of APSRTC. I have selected in written.reply to bhanudammoju@gmail.com thank u.
In order to increase efficiency and reduce co emissions and other emissions, clear coal technologies are receiving major attention. What are these ?
What causes turbocharger surging?
What is the circulation of I.O. pump of diesel engine?
What is the purpose of turning gear
hi if anyone have ntpc q previous year ...send me yogessuccess@gmail.com
calculate the expantion of steel bar 2,5 long if its temperature rises from 20 degrees to 250 degrees and its co effient of expantion is 0,000011 mm degrees
What will happened if two gear boxes in parallel are working with different motor speeds?
If you have a valve with an applied pressure, how do you determine the stress to the closed and open valve?
What is the normal vacuum pressure in a steam turbine atmospheric condenser?
Where id the warm side of a refrigeration system?
