why we conclude the area% for the chromatographic purity?
- 1 Answers
- 7198 Views
- Amneal Pharmaceuticals, Lupin, I also Faced
- E-Mail Answers
Answer / prakash
1.the absorbance of the analyte peak should not be saturate either below or above 1000 milli absorance Unit.
2. if go for diluted standard level the analyte peak absorbance response should same compare to your high level absorbance response.
3. if you calculate the result either %area normalization or diluted standard level the result should same.
in this case, only we can proceed %area normalization method.
| Is This Answer Correct ? | 2 Yes | 0 No |
What is linearity in HPLC and how will you test?
how you fix the limits of impurities?
What is the difference between Spectroscopy and spectrophotometry,What are the applications?
4 Answers Caplin Point, Cipla,
What is the pilot-plant in pharma sector.
What is the use of Holmium (III) Oxide???
why we use only sucrose in the calibration of polarimeter?
How to establish relative response factor for hplc. Why it is required?
Why linearity of detector performed in HPLC calibration
what is mass spectra ? why it is necessary ?
Why used 0.02% v/v solution of toluene in hexane for calibration of UV.
what is the difference between potentiometric titration and karl fischer titration?
some compound havving uv region but not give much more response during hplc analysis
Organic Chemistry 
