Answer / rachuri_sree

Digital signal means either True or False. Only 2 states
will be there. Example for this is pushbutton,Hot metal
detector,proxy etc.
Analog means the signal will vary with conditions. out put
may be 4-20mA, 0-20mA,0-10V,0-5V etc. examples are
pressure,flow transducers,RTD,Thermocouple etc

Answer / pallavi singh

analog means the quantity can take an infinite number of
continuous values in a range.for example weight of a
person,height of the person,pressure of fluid etc.
digital means only discrete values like on and off;0 and
1,0volts and 5 volts,true and false....etc

Answer / pdbhatt69

Analog means continusous varying system, for example it can
vary from 0 to maximum value continusouy sinusoidal or ramp
or by folowing any curve but continuos whereas in digital
there are ony two state(0 & 1) which changes in step from 0
to 1 i.e. discrete values.In Digital system, signal can be
reproduced at receiving end exactly with discrete values
signals received.

why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.

0 Answers   Alstom,

---

given data are load current & power factor cable core size? plz any one update the calculation formula

0 Answers  

---

WHATS THE DIFFERENCE IN USING THE 125% AND THE 250% FACTOR OF SAFETY IN CALCULATING CIRCUIT BREAKERS CAPACITY IN MOTOR APPLICATION??

0 Answers  

---

what will happen if the connections of protection ct reverse? will it burn the ct?

2 Answers  

---

while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?

0 Answers   Voltech,

---

What is the frequency of dc current????

4 Answers   SCS,

---

IN 6.6KV 3 phase switch gear .i will give 6.6kv to R phase only to earth in during H.v testing (through H.v KIT).what happen remaining phases.how much voltage get remaining phases.why? explain.

1 Answers  

---

how to select size of hardware for linking aluminium busbar is it depend on area of busbar or current flowing through bus bar

0 Answers  

---

why neutral and earth should not be connected on 3 phase 440v/50c/s supply at consumer side. where as on 25kv/ac/50c/s railway traction substation neutral and earth will be connected and track at substation. and track will act as neutral and earth. Reasons for this is needed urgently

4 Answers  

---

use of choke in APFC panels

2 Answers   Kemrock,

---

why white color LED light is not possible?

1 Answers  

---

what is KA rating and how can we choose switchgears on applications

0 Answers  

---