Answer / sridhar nayak

speed control
speed of motor N-120f/p*(1-s)
so sppe can be control by changing following parameter i.e
f,slip, p-number of pole

Answer / sunil kumar

THERE ARE MANY DRIVES ARE AVAILABLES FOR CONTROLLING THE
SPEED OF AC MOTORS SUCH AS VVVF DRIVES, SPRS,FLUID COUPLING
ETC.

Answer / pillay

the speed of an AC motor is dependent on number
of poles and frequency driving it as per the
speed formula already given by Mr sridher nayak
as SPEED =120f/p
So with the use of a frequency converter (vsd)one
can easily and safely vary the speed(by changing
the frequency to make the motor run at whatever
speed you want) OR
if your motor comes prewound with multiple pole
selectable winding, then with the help of change
over contactors you may have options for different
speed but they come with limitations in power and
fixed speed like 750,1000,1500 3000 rpm
Other means as rheostat, variable voltage and anything else will
not give you a safe, economical and reliable long term speed
control.

Answer / harish kumar

more then that above formula is there any thing

Answer / manikanta kumar gopi

I think as per the answer of Mr.G.sreenivasalareddy
Frequency control method and Rheostatic method are same.am
i correct?

Answer / srikanth

Speed of the 3 phase motor can be controlled by Variable
frequency drive. Speed should not be exceeding the rated
RPM of the motor.

Answer / g.sreenivasalareddy

Frequence control,Voltage control,rehostatic control

my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.

0 Answers  

why transformer fuse wire is very thin as compared to home fuse wire while voltage lavel is low

1 Answers  

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers  

what is differnce between grounding and earthing or both are same?

3 Answers  

how we can calculate the efficiency of a diesel generator ?

0 Answers  

how tubelight circuit is connected and how it works?

7 Answers   Punj Lloyd Ltd,

How will you calaculate the Ct ratio based on connected load 500KVA,and 11KV supply ?

3 Answers  

Why short ckt does not happen when solenoid coil connected to supply. as its a wire only.

1 Answers   Siemens,

what is the advantage of Cathodic eathing system and what is the basic principle and how itis working, please explain clearly .

2 Answers   Meinhardt,

does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain

0 Answers  

why two contacts(in series) are using in closing circuit

3 Answers  

how to find the capacitance value of the motor while running??

0 Answers