HT/LT TRANSFORMER TEST?
No Answer is Posted For this Question
Be the First to Post Answer
How the over load setting for HT Motors calculated-provided in Numerical Relay
0 Answers Damodar Valley Corporation,
what is unit of inductance
12 Answers Bhel, Bosch, OSML, Vijai Electricals, Voltage,
VCB in closed position during opertion if vaccume break then what will happend? it has any protection ?
what is the principle of tubelight ??? what is the function of starter and choke ???
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
what is different between installation and commonissonig.
Working of microwave oven?
what is the difference between E.L.C.B & R.C.C.B?
1. What is the difference between ac induction motor and ac synchronous motor?
why earth fault current is always less than the o/c
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
Why resistance is not measure in running conditions of motor
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)