why the microcontroller so called 8051?/ and why the IC
starts with 74?
Answers were Sorted based on User's Feedback
Answer / balasairam.k
it is 8-8 bit processor 8000series
5-it has five interrupts
1 -serial port
so it is called as 8051
Is This Answer Correct ? | 115 Yes | 26 No |
Answer / balasubramanian
8051
8-8bit controller(Data BUS)
0-Romless device(except 8051,8052 has internal ROM) but 8031 other are dont have Internal ROM
5-5 interrupts(INT0,TF0,INT1,TF1,TI+RI)
1-Serial Communication(8-bit UART)
Is This Answer Correct ? | 27 Yes | 11 No |
Answer / mahendra singh yadav
because we give high voltage at 7 no. pin and low voltage at pin no. 4 so we apply bising at these pins ...so...itis 74
Is This Answer Correct ? | 22 Yes | 14 No |
Answer / pratik
8 - 8 bit processor.
0 - belongs to low -power Microcontroller family 8000 series .
5 - It has five Inturrupts.
1 - One serial output port.
Is This Answer Correct ? | 7 Yes | 1 No |
Answer / suraj thakur
8051 called 8051 because
8- 8 bit processor
5- 5 intreupt
1- serial port
and 74 series called 74 because
1= 7 pin low
2= 4 gate consist in each ic
like in 7400 consist 4 NAND gate
Is This Answer Correct ? | 18 Yes | 14 No |
Answer / shyam sundor ghosh
8 mean-8 bit processor 8000series
5 mean-it has five interrupts
1 mean -serial port
so it is called as 8051
IC starts with 74 because we give activation voltage of the
IC at 7 & 4 no. pin of the IC.
Is This Answer Correct ? | 12 Yes | 8 No |
Answer / dileep
8-8bit processor
5-Five interrupts(INT0,TF0,INT1,TF1,TI+RI
1-Serial port(UART)
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / mihir
the basic function 8051 is done by the op amp 741.tats y the ic begins with 74 series
Is This Answer Correct ? | 15 Yes | 47 No |
6. When Abis link is down, name the alarm that is generated at BSC
What is automation industries main category and sub category?
why rx level is negative in telecom?
What do you mean by effect of noise on carrier signal & what is noise segment
How much losses in microwave Link?
Alok and Bhanu play the following min-max game. Given the expression N = 9 + X + Y - Z Where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be 27 0.0 20 18
Why half-wave rectifiers are generally not used in dc power supply?
what is function of FIU 19,
why r u want to join this company
12. Multiprogramming nd multithreading.. Which of these are better? a.multiprogramming b.multithreading c.depends on the system d.both are efficient
What is meant by D-FF?
can i get all books inrpidshare