Interested to Buy Any Domain ? << Click Here >> for more details...
What is meant by D-FF?
- 16 Answers
- 33501 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / jyotsana verma
It is a storing device.It stores only one bit at a
time.It's output is same as the input.
| Is This Answer Correct ? | 34 Yes | 7 No |
Answer / radhar
delay flip flop which gives delay of 1bit .which can also
acts as switch
| Is This Answer Correct ? | 22 Yes | 0 No |
Answer / rajiv
its a Delay-flip flop.it gives a delay of 1 bit.always
works with every single clock pulse.
D flip flops are prefered in most of the designs.
| Is This Answer Correct ? | 19 Yes | 2 No |
D flip flop is called as data or delay flip flop.
| Is This Answer Correct ? | 7 Yes | 2 No |
Answer / madasuvenky
These flip-flops are very useful, as they form the basis for shift registers, which are an essential part of many electronic devices. The advantage of the D flip-flop over the D-type latch is that it "captures" the signal at the moment the clock goes high, and subsequent changes of the data line do not influence Q until the next rising clock edge. An exception is that some flip-flops have a "reset" signal input, which will reset Q (to zero), and may be either asynchronous or synchronous with the clock.
| Is This Answer Correct ? | 6 Yes | 1 No |
Answer / vasmatkar@hotmail.com
It is a storing device.It stores only one bit at a
time.It's output is same as the input.
I Agree with youJyotsana Verma
| Is This Answer Correct ? | 5 Yes | 1 No |
Answer / mathivanan
D-FF means Delay flipflop.1st input is given directly and
2nd input was complement of 1st one and output will be Q and Q'
| Is This Answer Correct ? | 3 Yes | 1 No |
Please somebody tell me the call flow for MO & MT call with diagram & complete explaination ?
Loop check when we do ???before solo run test or dis two activities not related .plz explain me
hi i am electronics & telecomm engg & appling for apprentiship written test and interview. pls forward me the syllabus & old question papers.I will be very much thankful to you. pis inform to 88.avinashkalegmail.com
plz provide me all previous HPCL examination papers of electronics and communication branch.
What can be the reasons of a Call drop?
what is the working principal of diode
What do you mean by effect of noise on carrier signal & what is noise segment
Mention some of the applications of controlled rectifier?
how many maximum signaling link can be created between two gsm switches and why?
why we not connect the 12 V batteries in parallel to get the more backup supply ? how to calculate the input wattage and output wattage of an UPS ?
how many ground terminal in 8086 microproccer?
did signal to noise ratio have block diagram
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
