our company have 750 kva oil transformer.still we have
facing a problem that is when voltage is 11.5 kv coming
from HT side then LT-side voltage is 420v or above at tape
1.please give me best solution to decrease the voltage.
Answers were Sorted based on User's Feedback
File a case against the seller if transformer values are different than those mentioned on specification plate.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / bhupendra k. patel
We have started our own consultancy service on the same
field. We have solved no. of problems related to transformer
design.
The problem you have posted seems quite interesting for us
and we are in a position to solve it. Can you provide us
some elaborative details of your above mentioned problem.
You can send us the problem details through mail.
With regards,
B.K.Patel (R&D Division)
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / thanigai1984
increase the load on that to decrease the
voltage...otherwise decrease the capacity of transformer...
Is This Answer Correct ? | 0 Yes | 1 No |
If a contactor need to replace with faulty one. what I want to check?
describe the A.C. Generator Testing procedure
In a company the lines carrying 33KV but the load is below 10000Volts so we know that <11KV we can put 11KV lines but the lines are 33KV,..so how we can step down the voltage to 11KV with out erecting a substation
Define relative stability.
Can I parallel 1 MVA generator with 1kVA Generator? if V, F, Ph Seq and Ph angles are same
What is the main feature of v/f control?
How to take Transformer oil Break down voltage test?
Why frequency changes due to load variation in power system ? i.e why when load increases frequency decreases?
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
Why and which type of tertiary winding is used in most of the power transformer?
what is a difference berween line voltage and phase voltage?
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??