What is a unit of gravity (Battery)
Answers were Sorted based on User's Feedback
Answer / reddy
unit less ( density of battery elctrolyte / water density)
| Is This Answer Correct ? | 20 Yes | 3 No |
Answer / shailendra singh
It is a unitless quantity like power factor. the specific
gravity of a fully charged battery is 1280.
| Is This Answer Correct ? | 15 Yes | 1 No |
Answer / krishan kumar
all are correct.
1.unit less ( density of battery elctrolyte / water density)
2 Its unit less quantity
3 It is a unitless quantity like power factor. the specific
gravity of a fully charged battery is 1280.
4 UNIT LESS
5 gm/cm3
6 It is Kilogram per meter cube or kg/m3
7 unit of GRAVITY IS g = 9.8 m/s2
| Is This Answer Correct ? | 1 Yes | 1 No |
Are we do it in single transformer with dual primary as 11 KV and 33 KV and constant output as 415 Volts?.
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
What is the fuction of UV & how it works in circut breakers? is it one type of relay?
HAI SENT HPCL APTITUDE QUESTION PAPER, MY EMAIL ID IS angus_eee04@rediffmail.com,angus_eee04@yahoo.com
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
what is the advantage of NiCd battery over Lead acid battery?
Why transformer neutral is earthed
What is fault level? How can be calculate the fault level?
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
5MVA TRANSFORMER SUDDENLY FAIL WITH THE PRV TRIPPING AND LARGE AMOUNT OF OIL SPREAD OUT? SO IT CAME BACK WITH THE REPAIRING WITH REASON THAT IT FAILS BCOZ OF TRANSIENT EFFECT? SO PLZ EXPLAIN HOW DOES IT HAPPENED?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)