explain me how a power factor is improved by adding a capacitor?what capacitor do to improve it?in simple words and in detail?thx

7 Answers  

---

solor panels arrange some angle,panel is flat fitted energy was produced or not why?

0 Answers  

---

What is proportional controller?

0 Answers  

---

How to do stting of vl250 siemens MCCB

0 Answers   Qatar Steel,

---

what do you mean by synchronous speed of a three phase induction motor?

5 Answers   FlexPoint,

---

What is meant by SPS Aluminium pipe in substations? Anyone knows whats this?

1 Answers   Amec,

---

what is the working principle of three point starter of dc motor?

1 Answers   Ashok Leyland, Cap Gemini, Infosys, Just Dial,

---

Then what do you call a transformer that is installed on the ground?"

1 Answers  

---

Energy metering: On the property I am renting, the supply voltage is 2 x 110 volts. These 2 x phases enter a energy meter which then exit the meter to over head lines to my house. Question 1. The meter is single phase 240 volts but is being used as 2 x phase(2 x 110volt), is this acceptable? if not, please give me the reasons. The meter details are as follows: 60Hz 15amp Imax 100 amp Kd 3,6 Wh/R 1 fase 3 hilos Model FX 231. I think it was manufactured in Brasil From this meter, the cables run along over head aluminum conductors,I estimate the cross sectional area to be 25mm diameter, but the neutral is only about 10mm square diameter, which cover a distance of 170 meters and then terminate with an underground cable of 65 meter length, total length = 235 meters. There must be a huge voltage drop over this length. This line is protected with 2 x 200 amp aluminum fuses after the meter, there is no main switch in the distribution board. These 2 phases connect directly onto 2 busbars. Surely the neutral should be the same size as the conductors if not more? Question2. What are your thoughts about this installation, should there be better protection, is the neutral too small? During the night, the lights dim then brighten all the time, this cannot be good for my electrical appliances. In my home, I only have a small electric geyser and fridge, my stove works off gas. But when i use other appliances like the washing machine or microwave oven, the light dim. The internal wiring of this house is done with solid hard drawn copper wires and of course, they have to be under rated. I am a retired electrician by trade, but not on the metering and over head mains side, my experience is on the factory maintenance side of things. Your expertise on these matters will be greatly appreciated. Please inform me how to rectify or make any improvements Kind regards, my power bill is very expensive, so I need to know how to bring it lower. Kind regards, Brian

1 Answers  

---

WHY DISEL GENRATOR SET SHUT DOWN IN OVER LOAD CONDITIONS

5 Answers   HMT,

---

how many single tension hardware are required on a double circuit transmission tower?

0 Answers  

---

In Plug used in house,Why Earth of the plug more thicker & deeper?

8 Answers   L&T,

---