what effect on electrical equipment if PF is gone over 0.996 in leading when p

what effect on electrical equipment if PF is gone over 0.996
in leading when provider say that its keep in minimum
0.996lagging

Question Posted / deepak thakur

3 Answers
7597 Views
ABB, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what effect on electrical equipment if PF is gone over 0.996 in leading when provider say that its..

Answer / 7anoter4

The interruption of a capacitive current can cause
dielectric problems for the switching device. The high
inrush currents can cause damage to the capacitors of the
capacitors bank and to weld the contacts of the switch
together.See[for instance]:
http://www.icrepq.com/ICREPQ'09/480-kulas.pdf

Is This Answer Correct ?

5 Yes

0 No

what effect on electrical equipment if PF is gone over 0.996 in leading when provider say that its..

Answer / varaprasad inavilli

Electrical charges will be more

Is This Answer Correct ?

1 Yes

0 No

what effect on electrical equipment if PF is gone over 0.996 in leading when provider say that its..

Answer / subbarayalu

Leading power factor results in higher receiving end voltage, which again results in increased power loss in Transformers & Cables same as lagging power factor.

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

while calculating the power absorbed by a resistor connected to the output of a half wave rectifier circuit should we use rms or average current? explain with reason.

1 Answers Vedanta,

What is a differential amplifier?

0 Answers

What is Traction? 1KVA Alternator, How much urrent taken?

0 Answers Bhel,

WHY DIODE IS CONNECTING ACROSS SWITCHES

5 Answers

What is the recommended voltage gap between Live and Earth and ,Earth and Neutral.If these are exceded what is the solution.

2 Answers

explain how the power is distributed from a power plant to a consumer.explain step wise in detail

1 Answers

what is neutral voltage

3 Answers Power Grid,

what is AB switch???

6 Answers NTPC, Simplex,

i have a motor 55kw how u will calculate cable specification for this motor

1 Answers

Why transformer rating in kVA not in kW?

5 Answers ABB,

There is 3phase power cable from 1 point to the other point which is 100m away. Two point equipped with power meter and recorded 1st point is 205kW while the 2nd is 202kW and each phase average carry 400amps. To calculate the resistance of the 3phase power cable, is the formula using will be P=I2R?

3 Answers

how to calculate the no. of turns in secondary side of CT?

1 Answers

For more Electrical Engineering Interview Questions Click Here