Answer / bikash c pal

I think The question who have asked, wanted to ask that "AT
THE TIME OF START-UP A POWER PLANT....." & NOT "AT THE TIME
OF INSTALLING THE POWER PLANT ...."-------------If my above
assumption is true, then the answer WILL BE as follows :-

TO BRING THE GENERATOR NEAR TO SYNCHRONUS SPEED DURING
START UP.

Answer / natrajan tt

normally nobodies given to the supply directly to the
generator.In a power plant installation time they are drawn
supply from grid and given to the step down transformer like
11kv/430v for boiler and turbine auxiliaries startup use,
otherwise if ur possible to giving the supply to generator
it will act like a motor.Breaker capacity & Cable size or no
of runs to be added.

Answer / venkatesan.j

In a gas power plant during initial light up the generator
is acted as motor to run the compressor to produce the
necessary air for compustion in combustion chamber.

Answer / s.p.p.pathirana

The perpose is connecting grid power to the power plant
generators for syncronized both the system such as
(volt,freqency,and phase sequence)generator or alternator
has coupled to the engine. according to the question that
motor will turn engine to the oposite derection and engine
may damaged. there for generator have protection system to
prevent this. its call reverse power protection. power
plant for support to the grid and have connected grid power
cable to the generators through individual there circuit
breakers. generator breaker cannot close with engine
standby mode. if this correct please try to understand.

Answer / ashish patil

In order to produce residuual magnitism there is seperate
exiter so there is no need to run generator as motor.

Answer / dayal varma

to chek the capacity of the cables and winding of the
generator are able to work in such a high power

For 132 KV line, PT or CVT which is prefered for measuring & protection? is there any IS or IEE standard available?

1 Answers  

why fault current time duration is calculated for 1 minutes?

1 Answers   Rockfort Engineering,

At what factor resistance r of a conductor depends?

0 Answers  

why the neutral point in connnection oscillates?

0 Answers   Avalon,

How can we get d.c series motor characteristics by using a.c induction motor?

1 Answers   IIT,

What is the general system requirement of alternator?

0 Answers  

What are books to be referred for KPTCL exam?

0 Answers  

What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.

0 Answers   GNFC,

difference between power surge and switching transient

0 Answers  

in a induction motor if we put capacitor across it will the power factor of the motor will improve? if yes how

6 Answers   Reliance,

A transformer is used to light a 24volts,70watts lamp from a 240a.c main.The current in the main cable is 0.35A. Calculate, (1) The efficiency of the transformer. (2) the current in the lamp.

1 Answers  

why capacitor bank shorted by resistance ( 3 terminal )

1 Answers