WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN
DISTRIBUTION LINES?
Answers were Sorted based on User's Feedback
Answer / raghu
it should be placed on both sides of transformer and on pole structures and at the begining of distribution network
Is This Answer Correct ? | 0 Yes | 3 No |
Answer / suresh pathipati
In HT Yard near Transformer incoming of HT Line
Is This Answer Correct ? | 1 Yes | 6 No |
Answer / sreekanth
in the distribution system,LAS are placed below the phase
and neutral wires.
Is This Answer Correct ? | 2 Yes | 8 No |
Answer / razaq ali
lightning arrester is installed on the top of distribution
tower.
Is This Answer Correct ? | 10 Yes | 19 No |
why use delta star x-mer in distribution system.
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
whether fibre optic cable in high voltage earth conductor is used for protection circuits
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
DISCUSS THE SHAFT MOUNTED D.C. GENERATOR ,BASED ON EXCITATION SYSTEM IN ELECTRICAL SYSTRM
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
I want to make street light with solar system ... What may I do for procedure and how much of estimation for each material ... If any one knows guide me and inform this id : aravindd7@gmail.com
Why size of HT cable is less then LT cable inspite of the fact that voltage is higher in HT cable?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
why are use corona ring in high tension line switchgear?
What is a surge supressor why its is used in synchronous generators
How to calculate the copper in HT motors if KW, RPM & Voltage is given
0 Answers Control Dynamics, NTPC,