highest voltage gain can be obtained from a ).CC

Categories >> Engineering >> Electronics Communications
Suggest New Category

highest voltage gain can be obtained from

a ).CC

b).CE

c).CB

d).Both CE and CB

Question Posted / utsav

14 Answers
34929 Views
Cisco, Ericsson, SRC, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

highest voltage gain can be obtained from a ).CC b).CE ..

Answer / allanki sanyasi rao

high voltage gain is obtained from CB configuration only.
because the input impedance is low and out impedance is
high in CB configuration. so we get maximum voltage gain in
CB. whereas for CE the input impedance is moderate and
output impedance is moderate. so we get maximum power gain
from CE. and CC voltage gain is approximately one. so this
will give maximum current gain. CC is used for impedance
matching. CC is also known as emitter follower. because of
its unity gain.

cb will have max voltate gain.
ce will have max power gain.
cc will have max current gain.

Is This Answer Correct ?

57 Yes

3 No

highest voltage gain can be obtained from a ).CC b).CE ..

Answer / vijay

Is This Answer Correct ?

27 Yes

7 No

highest voltage gain can be obtained from a ).CC b).CE ..

Answer / dhaval

we can get only voltage amplification from CB configuration
.And we can get voltage and current amplification from CE
configuration. so we get high voltage from both of CE & CB
configuration.

Is This Answer Correct ?

17 Yes

9 No

highest voltage gain can be obtained from a ).CC b).CE ..

Answer / ajay kumar yadav

Highest Volt gain in transister is CB

Is This Answer Correct ?

9 Yes

3 No

highest voltage gain can be obtained from a ).CC b).CE ..

Answer / guest

Is This Answer Correct ?

6 Yes

3 No

highest voltage gain can be obtained from a ).CC b).CE ..

Answer / sanyasir rao allanki

no doubt the maximum voltage gain will be obtained from CB
configuration only. for the answer 6: we dont connect any
resistors on either side of input and output. by its
connection we get input and output resistances. we know the
doping concentrations of emitter, base and collector.
depending upon the configuration we get input and output
impedences. nothing else.

Is This Answer Correct ?

3 Yes

0 No

highest voltage gain can be obtained from a ).CC b).CE ..

Answer / daxesh

Agree with ans 5.
and for above query that R will be considered same in both configuration. Then ans 5 is correct.

Is This Answer Correct ?

1 Yes

0 No

highest voltage gain can be obtained from a ).CC b).CE ..

Answer / tinku.kne@gmail.com

we can get highest voltage from cb configuration
coz, transistor iss a current contld device so, we 've max
current gain from ce mode and

Is This Answer Correct ?

1 Yes

0 No

highest voltage gain can be obtained from a ).CC b).CE ..

Answer / sanuj

I agree with ans 5.

@shilpi
I have a book in which same data is given... and that data is misprinted and is not reliable.
Better you refer a book of another writer.

Is This Answer Correct ?

1 Yes

0 No

highest voltage gain can be obtained from a ).CC b).CE ..

Answer / reema

i am agree with answer 5
highest voltage gain can be obtained by CB
because its input impedence is low and output impedence is
high so it can give highest voltage gain

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electronics Communications Interview Questions

2. What is the command to lock the TRX

0 Answers NSN,

Define hold time?

0 Answers

Op-amp is used mostly as an integrator than a differentiator. Explain why?

0 Answers

Explain why is an excess-3 code called an unweighted code?

0 Answers

Why is a portion of the lower sideband of the AM picture signal transmitted along with the carrier and full USB ? Does it need any correction somewhere in the television link ? If so where is it carried out ?

1 Answers

What is meant by lsb and msb?

0 Answers

What are encoders and decoders?

0 Answers

an unknown semiconductor has Eg=1.1ev and Nv=Nc.it is doped with 10^15 donors,where the donor level is 0.2ev below Ec. given that Ef is 0.25ev below Ec, calculate ni and the concentration of electrons and holes in the semiconductor at 300k.

1 Answers Universiti Malaysia Pahang,

Define what are the main purposes for which a cc amplifier may be used.

0 Answers

hi...i had completed B.E.in Electronics & Communication.i had applied Section Engineer in railway recruit ment 2012.I need previous year exam papers.

0 Answers RRB,

how to prepare for csir interview

1 Answers CSIR,

what is RISC processor???????

4 Answers

For more Electronics Communications Interview Questions Click Here