what is the fuction of electrical transducer in control
pannel?
Answers were Sorted based on User's Feedback
transducer is a device which gives initially 4mA when
auxiliary supply is given and depending upon the input it
varies from 4mA to 20mA. usually this will be sent to
remote like DCS .
i have seen voltage transducer and current transducers
practically with this design
Is This Answer Correct ? | 4 Yes | 2 No |
Answer / sujit kumar sahoo
Transducer is a device from one form to another
form. For example in pressure transmiter it converts
220v to (4-20mA), but in level transmiter it converts
certain height to current(mA).
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / pb mahajan
Transdusers are used to convert any physical quantity in to
electrical quantity.
Is This Answer Correct ? | 3 Yes | 2 No |
Answer / prashanth
Can anyone tell the exact answer for Electrical Transducers?
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / abebe
Electrical transducer is to convert electrical energy to
mechanical..by this u can know the answer
Is This Answer Correct ? | 0 Yes | 3 No |
Answer / krishna
Electrical transducer is to convert electrical energy to
mechanical..by this u can know the answer
Is This Answer Correct ? | 2 Yes | 11 No |
How can we find out earth leakage,(shock)in side the house?.. (with out ELCB)
block diagram of 2 ups system connected in parallel mode?
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
Is it possible to run HT motor through LT VFD (LT VFD supply given to Transformer LT side and transformer HT side connected to motor)
What is an Isolation Xformer? What is the use of it?
In our generating power station we get electric shock in the battery bank, what will be the reason?
what are effects of harmonics in the three phase a.c power system ?
send me all basic electrical question and answers
can we identify the direction of power flow in transmission line by after only looking the tower
7 Answers TNEB Tamil Nadu Electricity Board,
What happen if in three phase 440 v , when you check voltage by testor it glows except one phase and in the same time when you check by multimeter it shows 440 v in any two phase.what will be the reason...
How supply comes to your home?
how we calculate the withstansing current capacity of wires&cables?