why are we maintaining some specific gravity in battery ?
Answers were Sorted based on User's Feedback
Answer / s rams
in lead acid battery voltage develops due to chemical
reaction, for this purpose we maintain some(1.260)specific
gravity.
| Is This Answer Correct ? | 12 Yes | 1 No |
Answer / ajmack
The specific gravity is a measure of teh state of charge of
teh battery cell and the health (concentration) of the
electrolyte. E.g. if the battery is discharged the SG is
lower, and if the electrolyte has been diluted by too much
water the SG is lower. If the battery does not charge up to
nominal terminal voltage, you can consider changing the
electrolyte. In general, lead acid batteries should be
replaced instead.
| Is This Answer Correct ? | 9 Yes | 0 No |
Answer / bilal
the presence of electrolyte is a must in a battery. for
example H2SO4 in lead acid storage battery (the one which
we use in vehicles). during discharging of this battery,
the acid gets used up in the redox reactions and thus
specific gravity falls and when it goes below a certain
level, the battery needs recharging. thus it is necessary
to maintain the sp. gravity of the electrolyte so that the
battery works properly.
| Is This Answer Correct ? | 1 Yes | 1 No |
Answer / pillay
The state of the SG in a battery is the indicator of the charge of the battery. So you charge the battery to maintain the sg of the battery.
| Is This Answer Correct ? | 0 Yes | 1 No |
AC covered area by ton calculation
Why efficiency in thermal power plant is low?
what is pilot wire protection? wer is it using?
What is class 2 coordination ?
what is the use of expulsition protective gap in 11Kv line.
i asked a funny question in Electrical ohms law V=IR in const temp voltage is directly proportional to current Power p=VI cos@ in that formula Voltage is indirectly proportional to current Try to give me the fact what is happening in Electrical.. contact Thanigai_1984@yahoo.co.in
A 60W,250V bulb when connected to a 230V supply will it give more light or less or will be give normal light?
How the over load setting for HT Motors calculated-provided in Numerical Relay
0 Answers Damodar Valley Corporation,
why is the transmission voltage is multiple of 11?
campared to ac, in dc corona loss is
What is basic fundamental for choosing NGR or NGT for any generator neutral grounding
what are the different types and applications of compressors?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)