Answer / hardik

its a closed vessel where incoming water is converted in to
high pressure steam to run the turbine shaft which attached
to generator will produce the power..

Answer / harikrishna

boiler is a heat exchanger, it is to convert water into
steam.

Answer / sri

Basically boiler is a steam generator. Water is converted
to steam. That steam is used for many purposes like rotating
turbines, heating etc..Fuel to boiler can be either liquid
or solid fuel

Answer / subhaveeran

boiler is one of the heat exchangers whose sole function is to convert water into steam irrespective of high pressure or medium pressure steam.the pressure generation is based on the temperature,design and capacity of the boiler which is used for the steam generation.

Answer / karthick

a boiler is pressure vessel and is used to increase the
pressure and temperature of the fluid

Answer / santhakumar

boiler is the vessel used in converted into water to steam.
using on steam power plant

Answer / yoga krishna

Boiler is a pressure vessel,which is tranfer the heat from
source to fluid contained in it. finally we can say tht ,it
is a heat exchanger.

Answer / a s chauhan

According to the Indian Boiler Regulation 1950- "A boiler is a closed vessel exceeding 22.75 liter ( 5 galons) to generate steam under pressure and includes any mountings or fittings attached to such vessel which is wholly or partialy under pressurewhen steam is shutt off"

Answer / abhishekgiri

Boiler is a device which use
to generate steam at a
constant pressure and
desired temp.

tansen was singer in whose mugal emperor

3 Answers   Concor,

What is the lower part of connecting rod?

2 Answers   RRB,

What is fit tolerance limit

2 Answers   Ecil,

16 inch = 1 ______________?

5 Answers  

What is a purpose of slow firing before commissioning of bagasse based boiler. and what is the water requirement for make up?

1 Answers  

what is the effect of reheat on rakine cycle? 1.efficiency increases 2.workt output increses 3. both 4. none of these.

5 Answers   Jindal, TATA, Thermax,

what is the basic optimal difference among isothermal,isentropic and adiabatic processess( with charts of each)??

0 Answers   BARC, NTPC,

HOW TO SELECT DG SETS AND DETAILED INFORMATION OF THE TERMS INVOLVED IN THE BROCHURES OF THE COMPANY?

0 Answers  

1) Any pipe line working fluid may water / steam on it one manual isolation valve suppose one side of valve 6 kg/ cm^2 pressure (i.e. up stream) and other side is “ 0” kg/ cm^2 pressure(i.e. down stream) . So how much Tourqe required for opening the valve in terms of Newton force wheather normal man can open this valve. (for reference pipe nominal bore is 100 NB )

0 Answers   Ansaldo,

A simple problem involing in hoops stress. For sphere: M= [3/2]*p*V*[density of pressure vessel material/Maximum working stress it can tolerate] For Thin walled pressure walls: Hoops stress or stress in the radial direction =p*r/2t ?

0 Answers   Bhel, JPMorgan Chase,

Explain the importance of thermodynamics laws in mechanical engineering?

0 Answers  

What is the diffrence between four strock and two strock ic engine

14 Answers   Alkem Labs, Mechanical,