In a Steam Turbine, where does the maximum loss of
efficiency occur ?
Answers were Sorted based on User's Feedback
Answer / birare sachin k.
while hot steam flows after that most of that has to
condense properly and its total heat energy must utilised
efficiently but practically it is difficult. so maximum
loss of efficiency occurs inside the condenser.
| Is This Answer Correct ? | 14 Yes | 2 No |
Answer / tamir
In condenser where we extract latent heat from steam to
change is state from gas to liquid for recycle in boiler as
a treated water to compensate that loss we have to burn more
fuel in furnace so that our plant efficiency would lost .
| Is This Answer Correct ? | 13 Yes | 1 No |
Answer / hole jitendra atmaram
Not Proper angle of Blade and Inlet of Steam throu
Nozzles ,Improper Insulation, Non Propeer Fitting Of
Valves ar accessories above factors did the Maximum Loss of
efficiency
| Is This Answer Correct ? | 22 Yes | 13 No |
Answer / hardik
IN POWER PLANT HEAT LOSS OCCUR IN CONDENSER BUT ONLY FOR STEAM TURBINE STEAM TEMPERATURE IS MAIN POINT WHICH IS EFFECTIVE ON STEAM TURBINE EFFICIENCY.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / kiran
loss occurs in terms of properly defining the nozzle
construction and blade angle usage and major part occurs @
condensing the steam,where process heat is loss through
cooling tower as to send back cool feed water to boiler.....
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / devanesan
Maximum heat loss in condenser(Aprox. 550kj/kcal.). Other
than that tip loss or leaving loss, throttling loss are the
losses will reduce the efficiency.
| Is This Answer Correct ? | 0 Yes | 0 No |
what is the function of nozzle? what happend when the fluid flow through a taper pipe i.e. what about inlet and outlet velocity, pressure,
what is the difference between clutch and gear ?
Heavy fuel oil sulfur content and counter measures?
what is meant by hybrid vehicles?
What causes cylinder liner-wear down?
What is the principle of operation of simple jet propulsion system?
why we done superheated steam in to saturated steam.
explain loop current method of circuit analysis. explain by using a typical example
what is diferent types of drillmachines?
how to define nomenclature of bearing.
How are the pneumatic system and the hydraulic system similar?
What happened if the exhaust valve is leaking?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)