Answer / guest

The most important criteria for the calculation of cable
size is the
a)load amps b)Voltage drop due to distance, c)The amp
rating of the breaker that is going to be connected. d)type
of cable d)how and where the cable is going to placed.
With a known particular load say 250 amps you may also
already know the distance and the type of cable you are
going to use say xlpe single core or 3core in trunking or
under ground.
From the cable table under the correct appropriate amp
rating the cable size is selected. The voltage drop can be
calculated now, If necessary the cable size is increased to
meet the requirement.Than finally the amp rating of the sub
cct breaker is determined.This breaker should be able to
protect the cable and allow for the use of the particular
load.

Answer / sandeep

can you please get me the CABLE TABLE.

why we step/down voltage in multipul of 11kv?

4 Answers   Siemens,

---

what are the highly demanded courses for electrical engg. who finished his b.tech

2 Answers  

---

what are difference between indoor and out door substation

1 Answers  

---

When a fourth resistor is connected in series with three resistors, the total resistance

1 Answers   ITI,

---

describe the A.C. Generator Testing procedure

0 Answers  

---

Re: can you give main difference between ELCB 2pole And RCCB 2pole? And how this devices operated?

4 Answers  

---

why the electrical plug point pin(earth) size in max

1 Answers   Autoneum Nittoku, Bajaj,

---

The Frequency is measured by _________ bridge ?

3 Answers  

---

Load break swicth maintenance procedure.

0 Answers   KSEB, L&T, Siemens,

---

what collector is used for 100kmph-120kmph tracion application?

3 Answers   APTransco,

---

block diagram of 2 ups system connected in parallel mode?

0 Answers  

---

difference between a diode and thyristor?

0 Answers  

---