Answer / vishal ingle

lighteining protection can be achieved by using lightening
arrestors at the highest points in an industry if its area
is less. but for larger area to be covered, several
lightening areestors are to be used. or
in the EHV substations, continuous earth wire mesh is
formed covering entire area.

Answer / prakash soni

1)Several lightining arrester is used at the top of towers
lightning mast ,& buildings.
2)shild or ground wires are used above transmission line.
Gound wires are also used above & throughout the sub
station .
3)40mm or 32mm Ms rod are placed to entire area of plant
with wealding joints.
All lighting arresters and ground wires are connected
through the MS gried.

what is the working of ups.

7 Answers  

---

What is ill conditioned power system?

1 Answers  

---

What is dynamo?How it works and what is the function of dynamo in a DG.

0 Answers  

---

What is the basic working principle of Tri vector meter?

5 Answers   TCS,

---

where to use 3.5 core and 4 core cables, will this vary for type of loads

1 Answers   KSBC, Medreich,

---

What is required of exietation to the alternater.

3 Answers  

---

Why capacitor blocks DC current?

2 Answers  

---

Diff between Earthed & Unearthed cable ?

1 Answers   Torrent Pharma,

---

Which of the following are the important limitations of rod gap surge arresters? 1. They are not capable of selling off power frequency follow up current. 2. After a discharge, the rods are destroyed completely. 3. Performance is affected by climatic conditions. Use the following codes for selecting the correct answer. Codes: (a)1, 2 and 3 (b)1 and 2 (c)2 and 3 (d)1 and 3

1 Answers  

---

why always out of the 3 phase(RYB) of supply, in Y phase w.r.t the voltage is higher? on R & B phase the voltage will be lower as compared to Y phase?

1 Answers  

---

why are the a.c.series motors preferred for electric traction

4 Answers  

---

why generator one end side star neutral point given? if this point not given what happen?

1 Answers  

---